SPORTS PEN

Unzip Bag

Label has extra information from the manufacturer.
Set up Blower along back of event space

Untie Straps and Roll the inflatable out into event space. Unfold the sides and adjust the footprint in the event space.
(Wrap the Straps around the Blower handle so they are easy to find later)
Connect Blower

Put the Air Inlet tube of the inflatable over the Blower pipe and pull the strap tight around the pipe to create a tight seal. (The label should face up) Find the large zipper on the back of the inflatable and make sure it is closed.
Turn on Blower

Turn on the blower to inflate the Pen. Keep an eye on it as it inflates so it doesn’t run into or scrape anything as it expands. Make sure the Inlet tube is not kinked or twisted so it gets the maximum amount of air.
Hang the Backdrop

Unroll the backdrop and attach the D-Rings on the top of the backdrop to the clips hanging inside the Sports Pen (Start from one side and move across, Use a step stool if needed.)
Backdrop Side Hooks

Attach the side strings to the hooks on the sides of the pen.
Tie Down the Inflatable

Tie each strap to a sandbag or sturdy object at the event location like a Tree or Railing. (Use sturdy objects first if available and won’t block pathways or hurt any structures) Make sure all straps are pulled tight with no slack. (If Indoors you will not need to tie down the inflatable)

Backpack Fan is about 5.5 lbs. Battery Belt is about 8 lbs.

Get a chair and lay Fizzy out in front with Zipper open and access to the Legs.

Place Fizzy feet on the floor in proper orientation so you’ll be able to step into them.
Slide your legs into the Fizzy legs so your feet go all the way down.
Reach down into the feet and feel for the Ankle and Foot Straps

Velcro the straps around your ankle, and over your foot to lock your foot to Fizzy’s foot.
Make sure your heal is pressed tight against the base of the Ankle Strap. And both Straps are tight so you have the best range of motion.
Put on Battery Belt. Snap Buckle in front, with Battery in back.

Use “Battery A” first at each event.
Put on Fan Backpack.

Connect straps across your chest. Then connect hanging clips to Battery Belt loops.
Connect Fan Hose to Fizzy Vent Hole

Align the white velcro hose square with the white velcro vent square so the holes line up.
Connect the Battery connector wire to the Fan connector wire

You can loop one of the wires through the battery belt so it isn’t flapping as much when you are inside.
Zip yourself up inside of Fizzy

Zip up fizzy and allow the costume to fully inflate before interacting with anybody. Intake will be slow if the costume is folded over the Vent hole. Try to keep the Vent hole clear while inflating and performing.
Your ready to be FIZZY